All error codes
Mistake #1: Overheating the room
Mistake #2: Steam generator overheating
Mistake #3: Process Overheating
Mistake #4: Overpressure Error
Mistake #5: Sterilization pressure too low
Mistake #6: Sterilization temperature too low
Mistake #7: Too much pressure when drying
Mistake #8: Too many steam pulses / no water
Mistake #10: Room Heating Error
Error #11: Steam Generator Heating Error
Error #12: Pre-vacuum / output check failed
Mistake #14: Pressure on standby
Error #17: V3 Valve / HEPA Filter Error
Error #18: Pressure sensor error
Error #19: USB disk error / change disk
Mistake #20: Minimum Room Temperature
Error #21: Room temperature sensor failure
Error #22: Steam Generator Temperature Sensor Failure
Error #23: Process temperature sensor failure
Mistake #24: The autoclave is too cold
Error #31: Internal Flash Error
All messages
Welcome to our Enbio guide
Our Enbio autoclaves are designed to provide effective and safe sterilization, but like any technical equipment, they can sometimes display error messages.
This guide is intended to help you quickly understand and resolve any issues you may encounter.
To access the guide, simply click on the error displayed on your autoclave.
If you cannot find the solution or if the problem persists, our technical service is available to assist you.
